![]() Address representations differ from manufacturer to manufacturer. Addresses of the devices are built on the basis of names, PLC slot numbers, words and bit numbers. ![]() Each bit in these registers specifies a function. Inside the PLC, we have various registers like output, input, status and binary. In the above example, the address for the analogue input is I: 1.0 and the converted raw data is divided by 10,000 and added to offset to implement a linear transfer function likeĪ number of free Ladder programming tutorials are available on the Internet. Similarly, an SCL is an instruction used to read and scale an analogue input to a corresponding physical value like temperature or pressure. ![]() The AWA instruction sends a specified number of characters (for example, 50) of the source tag (ST14:0) to a PLC serial port 2 and appends either one or two pre-defined characters. Sub-routines are implemented as another ladder.Ī typical example of a block used for RS232 programming is AWA (Fig. We redraw the wiring diagram using two vertical lines to represent input power rails and stringing the rest of the circuit between these. Ladder program is similar to the wiring diagram of the circuit.
0 Comments
Leave a Reply. |